Astroprints 1.25" Filter Holder for Celestron Origin Telescope

Astroprints 1.25" Filter Holder for Celestron Origin Telescope

Additional filter inserts for the Celestron Origin Home Observatory allow you to switch between different filters in a matter of seconds. You can use as many filter inserts as you like. This allows you to use any combination of filters for photography. This eliminates the need to change filters during photography and allows you to change filters quickly by using additional filter drawers.

The filter holder is printed with sturdy PETG. The middle section is made of TPU, which is very similar to rubber. Thanks to the flexible TPU material, all 1.25" filters can be used in it without having to worry about the fit accuracy of your filter manufacturer.

Note: Unfortunately, it is not possible to offer ready-made filter holders with magnets already glued in, as Celestron positions the magnets differently for each telescope. Only then is the filter holder specially made for the respective Origin telescope and fitted with the appropriate magnets. As these are neodymium magnets, it is essential to observe the correct pole direction during installation. Printed instructions in English are included. You will also need tweezers and a suitable adhesive for installation. The manufacturer recommends "Uhu Sekundenkleber blitzschnell PRÄZISION", but most other - low viscosity - superglues should also work.

- Filter holder
- 2 Neodymium magnets

Safety informations: PDF Download