Lunt O-Rings for Pressure-Tuner of MT & THa Solar Telescopes - 2x 34 mm and 2x 32 mm

Lunt O-Rings for Pressure-Tuner of MT & THa Solar Telescopes - 34 and 32 mm

Two rubber O-rings are installed into the Pressure-Tuner of Lunt Solar Systems solar telescopes to seal the air-pressure tuning system. Over time, the rubber of this O-rings can age and become porous, whereby the air-pressure can then no longer be maintained. When this happens, a old O-ring can be replaced by this spare part. The replacement is simple and can be done by the user. Installation instructions as a PDF can be found here.

Please be sure to note:
Depending on the production series, the diameters of the Pressure-Tuner pistons can vary slightly. There are pistons for O-rings with 32 mm inner diameter and 40 mm outer diameter, and pistons for O-rings with 34 mm inner diameter and 42 mm outer diameter.

Please check the diameter of your old O-rings, this spare part set includes two O-rings with an inner diameter of 34 mm and an outer diameter of 42 mm as well as two O-rings with an inner diameter of 32 mm and an outer diameter of 40 mm. It is suitable for 60MT, 80MT, 100MT, 130MT, and 152THa.

The LS50THa telescopes have Pressure-Tuners with smaller diameters, for these you will need red replacement O-rings with item number 0558320.

After replacing an O-ring, the piston and cylinder of the Pressure-Tuner can be re-greased with the grease included in this kit.

Features

Inner diameter big rings: 34 mm

Outer diameter big rings: 42 mm

Inner diameter small rings: 32 mm

Outer diameter small rings: 40 mm

Cannot be used separately, only as a replacement part on the Pressure-Tuner of MT and THa telescopes from Lunt Solar Systems

It does not matter what blocking-filter is at the MT or THa telescope.

Safety informations: PDF Download