Manufacturer: -TS Zubehör
Product number: TSSCHUB1

EUR 39,00


incl. 19 % VAT (DE)  
The VAT indicated refers to that applicable in Germany. After logging in, the VAT amount is adjusted to the applicable VAT of the stored delivery country. Therefore, the final price may vary accordingly.
excl. 6.95 € shipping costs (DE)  
Please log in to calculate shipping costs to your country.
more details to the shipping costs ...

  • On stock



Order:
Please select following options first:



rating: 5.0 of 5
  • Details..
  • Technical data..
  • In the box..
TS Filter Drawer for 1.25" filters
Additional filter drawer for the TS filter quick changer allow for changing between different filters within seconds. There is no limit to the number of different filters you can use and it is even possible to mix 1.25" and 2" drawers if needed! Thus you can use any filter combination photographically or visually.

Practical advice from Teleskop-Service:
We recommend one drawer for each filter. Interchanging of filters during by screwing while photographing or observing is rather unfunctional.
Suitable for:1.25" mounted filters with M28 filter thread
Max. possible height of filter cell:7.0 mm (without male thread)
TS Drawer for 1.25" filters



Recommended accessories

Reviews

Written by Robert Weizenmüller
on 2023-10-25

"Beobachtung und Astrofotografie"

Written by Robert Weizenmüller
on 2023-06-22

"macht was es soll"

Written by Ullrich Linnemann
on 2021-10-13

"Sehr gute Verarbeitung. "

Written by Peter Raab
on 2016-09-13

"Super, leichtes Gewicht"

Written by Marius Dinga
on 2016-07-28

"I preffer this sistem because it is lighter and with lower profile( vs. filter wheel). It is strong and reliable,too. I think I´ll buy another drawer, in order to have the next filter ready for change. But, there is a problem. The female T thread (telescope side) has 2mm length. The 2""/T2 adapters have a large variety of T thread length(MPCC has 5mm). If the thread is just a little longer than 2mm, you cannot insert or extract the drawer because the back wall is too fixed. Well, you can use tuning rings to have that 2mm thread length. I preffer to have the male thread 1mm longer than female, just for safety. Solution: just cut 1.5mm(or what you need) on the edge of back wall of the drawer ( with 42mm length)."