Lunt O-Ring for Pressure-Tuner of MT & THa Solar Telescopes - 34 mm
Two rubber O-rings are installed into the Pressure-Tuner of Lunt Solar Systems solar telescopes to seal the air-pressure tuning system. Over time, the rubber of this O-rings can age and become porous, whereby the air-pressure can then no longer be maintained. When this happens, a old O-ring can be replaced by this spare part. The replacement is simple and can be done by the user. Installation instructions as a PDF can be found
here.
Please be sure to note:Depending on the production series, the diameters of the Pressure-Tuner pistons can vary slightly. There are pistons for O-rings with 32 mm inner diameter and 40 mm outer diameter, and pistons for O-rings with 34 mm inner diameter and 42 mm outer diameter.
Please check the diameter of your old O-rings, this spare part is an O-ring with 34 mm inner diameter and 42 mm outer diameter.
If you need the smaller O-ring with 32 mm inner diameter and 40 mm outer diameter, this is the spare part with item number 0558330.
The LS50THa telescopes have Pressure-Tuners with smaller diameters, for these you will need replacement O-rings with item number 0558320.
After replacing a O-ring, the piston and cylinder of the Pressure-Tuner can be re-greased with grease available under item number 0558350.
Features♦ Inner diameter: 34 mm
♦ Outer diameter: 42 mm
♦ Cannot be used separately, only as a replacement part on the Pressure-Tuner of MT and THa telescopes from Lunt Solar Systems
♦ It does not matter what blocking-filter is at the MT or THa telescope.