TS-Optics Heater Kit for Newtonian Secondaries glued on 2" holder

TS-Optics Heater Kit for Newtonian Secondary Mirrors

The Problem:
Due to heat emission into the sky, the back of a Newtonian secondary mirror can become colder during the night, and so the used surface, resulting in the formation of dew. A heating can prevent from this problem.

Usual heaters cannot be installed on the back of a secondary mirror glued to a holder having almost the diameter of the secondary.

Solution:
This wrap-around heater heats the holder, which then transfers the heat to the secondary.

Installation:

Installation is very simple. Simply wrap the heater around the stalk that your secondary mirror is atached to as indicated in the drawings below. Then wrap the black neoprene heat insulator around the heater. Use the included elastic band or black elesctrical tape to secure this in place.

Electrical connection:

The heater wires can be taped down along one of the spider vanes (we recommend using black electrical tape). The heater cables are very thin and will not affect image quality if placed in-line with the spider vane, however, as an option, you can also use the included flat copper strip with adhesive backing as a feed to the heater if you have experience with electrics.

Also included with your heater is a Female-to-Female RCA connector and a 6? RCA extension cord so that you can extend a power lead to your Kendrick dew controller. We recommend a dew controller setting of 10% to 20% for this heater. Only use higher settings if your mirror is already dewed over and you need to clear it or your observing environment requires it.

Compatibility

This heater is designed to work with TS, Skywatcher, Meade, Celestron, Orion and other Newtonians and Dobsonian telescopes with secondary mirrors glued to holders in form of a stalk of almost the diamater of the secondary.

Important note

The manufacturer provides the heater with blade receptacles and adapts to RCA. The blade connectors are not insulated and can cause a short circuit, so it is advisable to use insulating tape at least on one of the two connections.

Question:
What are the copper strips for??

Answer from Teleskop-Service:
The easiest method is to use the 2-piece white wires. These have narrow ?quick connectors? that allow you to drill a small hole to allow the connectors to pass through shrouds. We also give you adhesive-backed foil tape that are electrically conductive and take almost 0 of your light path. NOTE: To use this option, you will need to solder common wire leads to each end on the foil tape. You need 1 foil strip for each of +POS and -NEG.